Bissell REVOLUTION PROHEAT 2X 1858 Instructions Manual page 11

Empty Dirty Water Tank
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
1
To remove dirty water
tank, press down on the
coloured tank handle.
Quick Empty:
4
Pull the rubber tab
(located at the corner
of the top of the tank)
and tilt to pour. When
closing the rubber tab,
make sure all edges are
sealed tight.
Final Rinse & Clean:
Unscrew ring at bottom
of tank by turning
counterclockwise.
Gently remove the float
stack, rinse and clean.
Once clean, return float
stack into the tank by
lining up the arrows
to point at each other.
With the arrows aligned,
the float stack will lock
into place. Return the
ring and twist clockwise
to lock. Water may leak
if the ring is not fully
tightened.
2
Tilt the tank slightly toward
you. Grab the handle and
tank with both hands.
5
6
Did You Know?
The Float Stack
is what prevents
your dirty
tank from
overflowing.
3
Pull dirty water tank up
and away to remove
(continue to step 4).
Clean the red filter
below the dirty
tank by wiping off
any remaining dirt
or debris.
Return Dirty Tank:
Angle the tank
and insert bottom
first. Then tilt the
tank toward the
machine and push
the top in until it
clicks into place.
www.BISSELL.com
11