ADJ PinPoint Gobo COLOR User Instructions page 6

PinPoint Gobo COLOR
The UC IR (sold separately) infrared remote gives you control of
various functions (See below). To control the fixture you must aim the
remote at the front of the fixture and be no more than 30 feet away.
The PinPoint Gobo COLOR is also compatible with the Airstream IR
app. The IR transmitter is available through any ADJ dealer or through
the ADJ parts website. Plug the transmitter into the headphone jack
of your iOS phone or tablet. To control your IR fixture you must raise
the volume to the maximum on your iOS phone or tablet and aim
the transmitter at the front of the fixture and be no more than 15
feet away. After you have purchased the Airstream IR transmitters,
the app is a free download from the app store for your iOS phone or
tablet. The app comes with 3 pages of control depending on the IR
fixture you are using. Please see below for IR functions including the
corresponding app page.
Works with App page 1.
STAND BY - Pressing this button will blackout the fixture. Press the
button again to return to the initial state. This button is also used to
switch between full on mode, 3.3W mode, and energy saving mode.
To switch between the modes see page 7.
FULL ON - Hold this button down to fully light up the unit. When you
let the button go, the unit will return to its previous state.
FADE/GOBO - Press this button to activate color fade mode.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the
color output intensity when static color mode is active.
STROBE - Press and hold this button for strobing
COLOR - Press this button to activate static color mode. Use buttons
1-9 to select your desired color.
1-9 - Use these buttons to select your desired color in static color
mode or your desired show when show mode is acive.
SHOW 0 - Press this button to activate show mode, and use buttons
1-4 to select fast color fade, fast color change, slow color fade, or
slow color change modes.
ADJ Products, LLC - www.adj.com - PinPoint Gobo COLOR User Manual Page 10
UC IR Remote & Airstream IR PinPoint Gobo COLOR
The ADJ LED RC2 infrared remote (Sold Separately) has many dif-
fernet functions and gives you complete control of your PinPoint
Gobo COLOR. To control the your desired fixture you must aim the
controller at the front of the fixture and be no more the 30 feet away.
BLACKOUT - Pressing this button will blackout the fixture. This but-
ton is also used to switch between full on mode, 3.3W mode, and en-
ergy saving mode. To switch between the modes see page 7.
SELECT PROG (PROGRAM) - Press this button to scroll through
fast fade, fast change, slow fade, and slow change. Press the Speed
button and use the +" & "-" buttons to adjust the program speed.
Press the Flash button to activate strobing and use the +" & "-" but-
tons to adjust the strobe speed.
MANUAL COLOR MODE - Press the R/G/B/A buttons to select one
of the four colors. Use the "+" & "-" buttons to adjust the output inten-
sity of each color. This color will now be saved to memory. When the
power is switched off and back on again, the same color will come
on. Press the Flash button to activate strobing and use the +" & "-"
buttons to adjust the strobe speed.
COLOR SELECT MODE - Press the "1" button to activate color se-
lect mode. Use the "+" & "-" buttons to scroll through the 64 color
macros. Press the Flash button to activate strobing and use the +" &
"-" buttons to adjust the strobe speed.
ADJ Products, LLC - www.adj.com - PinPoint Gobo COLOR User Manual Page 11
ADJ LED RC2 Remote