Mode Operation; Installation - ADJ PinPoint Gobo COLOR User Instructions

PinPoint Gobo COLOR
• Battery Power - To run the unit using Battery power, put the POWER
switch in the ON position.
Mode Button Lock:
The MODE button will lock itself after 30 seconds if nothing is
pressed. To unlock the unit, press the MODE button for 3 sec-
onds.

Mode Operation:

Each press of the MODE button will cycle through the different oper-
ating modes. The operating modes are listed below in the order that
they appear.
NOTE: When power is turned OFF and turned back ON, the unit
will start in the last operating mode.
Order of Operating Modes:
• 64 Color Macros • Fast Fade • Fast Change • Slow Fade • Slow
Change • LED Off
Pressing the MODE button again after LED Off will return the unit to
the first color macro. Starting the operating mode order at the begin-
ning.
PinPoint Gobo COLOR
The knobs located on the right side of unit are used to adjust the focus
and the zoom. For a tighter/narrow beam move the first/front knob to
the front of the fixture, and move the second knob to rear. For a wider
beam, move the first/front knob towards the middle of the fixture, and
move the second knob towards the middle as well. Adjust accordingly.
ADJ Products, LLC - www.adj.com - PinPoint Gobo COLOR User Manual Page 8
Operating Instructions
Focus and Zoom Adjustments
PinPoint Gobo COLOR
The PinPoint Gobo COLOR comes with 4 replaceable gobos (see
below). To install a gobo, remove the gobo holder by unscrewing the
thumb screw that is securing the gobo holder located at the top of the
fixture. Remove the retainer ring that holds the gobo in place. Install the
gobo and replace the retainer ring.
PinPoint Gobo COLOR
The PinPoint Gobo COLOR comes with a frost filter. To install the filter
remove gobo holder from the fixture. Remove the retainer ring that
holds the gobo in place. Install the filter and replace the retainer ring.
PinPoint Gobo COLOR
The unit has two ways that it can be installed. The unit includes
a X-Clip so that it can be installed on drop down ceilings. Always
ensure that the unit is firmly fixed to avoid vibration and slipping while
operating. Always ensure that the structure to which you are attach-
ing the unit is secure and is able to support a weight of 10 times the
unit's weight. Always use a safety cable that can hold 12 times the
weight of the unit when doing this type of installation. The safety
cable should go through the eye hole nut that holds the X-Clip base in
place.
You can also install using the magantic base. To do this, remove the
X-Clip base by unscrewing the eye hole bolt. Once removed the fix-
ture can be stuck to anything magnetic.
The equipment must be installed by a professional, and it must
be installed in a place where it is out of the reach of people's
grasp.
ADJ Products, LLC - www.adj.com - PinPoint Gobo COLOR User Manual Page 9
Gobo Install
Frost Filter Install

Installation