How To Install The Series 980/985 - Watlow Micro-Based Autotuning Control SERIES 980/985 User Manual

How to Install the Series 980/985

Figures 6,7 and 8 provide the Series 980/985's panel cutout and dimensions.
Do not, however, make your panel cutout until you are sure that you are
placing the control in the best location. Read the noise guidelines at the
beginning of this chapter before installing and wiring the Series 980/985.
Place the panel cutout in the desired location. Figure 6 shows you the
1.
panel cutout dimensions.
2.
To install, carefully insert the Series 980/985 into the panel cutout.
the unit in until the bezel is seated securely against the panel.
3.
Included with your control are two adjustable mounting brackets; one for the
top and one for the bottom of the control case. Installing the mounting
brackets requires access to the back side of the panel.
On the top and bottom of the case are a series of slots running the length of
the case. The first two shorter slots are for attaching the mounting brack-
ets. Figure 8 shows a side view with both mounting brackets.
4.
Loosen the mounting bracket screws with a Phillips screwdriver far enough
to allow for the panel thickness.
5.
Make sure that each bracket is placed in the first two slots from the front of
the control, with the head of the screw facing the back of the control. Refer
to Figure 8 for screw and bracket placement.
6.
To attach, place the bracket into the slots (head of the screw facing the
back of the control and push backward, securing the brackets to the control
case. Do the same for the other side of the control.
7. Make sure the Series 980/985 case is seated properly. Tighten the installa-
tion screws firmly against the panel to secure the unit in place.
8. To remove the unit from its enclosure, loosen the captive screw at the
bottom of the 980/985's front panel with a Phillips screwdriver. Pull the unit
from its case.
9.
To release the mounting brackets, push the brackets forward and pull out to
release them from the control case.
and
Install Wire, Chapter 2
Push
Removing the Series
980/985 chassis
from its case may
make mounting
easier.
WATLOW Series 980/985 User's Manual 11