Table of Contents
Advertisement
• To switch the electrode condition
indicator on the LCD ON or OFF, press
the SET button; press
options. Change the set with the SET
button, then press
to confirm and
to return to normal mode.
BATTERY REPLACEMENT
When the remaining battery life is less
than 10% the battery tag blinks on the
display to warn the user.
Battery Error Prevention System (BEPS)
If the battery is too weak ("0%") the display shows "bAtt",
"DEAD" for a few seconds then the meter powers off.
Immediately replace the batteries with new ones.
The batteries are accessed by opening the battery cover
on the back of the instrument. Remove protective boot
if present.
Replace the three 1.5V AAA alkaline batteries located in
the battery compartment, observing the indicated polarity.
Replace the battery cover
making sure that the gasket
is in place.
to exit setup
15
Advertisement
Table of Contents
