Table of Contents
Advertisement
Warning
Read all caution and safety
statements in this document
before performing any of the
instructions. Also see the Intel
®
Server Board and Server Chassis
Safety Information document at:
http://www.intel.com/support/
motherboards/server/sb/cs-010770
.htm
for complete safety information.
Intel
is a registered trademark of Intel Corporation or its subsidiaries in the United States and other countries. *Other names and brands may be claimed as the
®
property of others. Copyright © 2012, Intel Corporation. All rights reserved.
Thermal Operation and Configuration Requirements
To keep the system operating within supported maximum thermal limits, the system must meet the following operating and configuration
guidelines:
• Ambient in-let temperature cannot exceed 35 ºC and should not remain at this maximum level for long periods of time.
Doing so may affect long term reliability of the system.
• DIMM Population on CPU: Install DIMMs the in order; Channels A, B, and C. Start with 1
• All hard drive bays must be populated. Hard drive carriers either can be populated with a hard drive or supplied drive blank.
• The air duct must be installed at all times.
• The system top-cover must be installed at all times.
Warning
Caution
Installation and service
of this product is to be
performed only by
qualified service personnel
integration to avoid possible
damage to server board and/or
to avoid risk of injury from
electrical shock or energy
other components.
hazard.
ii
Tools Required
Observe normal ESD
[Electrostatic Discharge]
procedures during system
DIMM slot (blue) on each channel.
st
Phillips*
screwdriver
Anti-static
wrist strap
Advertisement
Table of Contents
