Installation - Electrolux ESL69200RO User Manual

24 www.electrolux.com
Capacity
1) Refer to the rating plate for other values.
2) Cold water connection is recommended for best washing performance.

13. INSTALLATION

There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Install the appliance under a kitchen
counter.
Put the appliance adjacent to a water tap
and a water drain.
For the venting of the appliance only
water hoses and mains cable openings
are necessary.
13.1 Adjusting the height of the
appliance
1. To adjust the front height of the
appliance, turn the 2 front feet
counterclockwise.
Place settings
The hose should not be
extended by more than
2 metres or water pump-
out problems may occur
Secure dishwasher with
brackets or screws provided
DISHWASHER
Gap on both sides should be
equal, & no greater than
5 mm per side.
If floor is not level, adjust
levelling legs to suit
15
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
SINK
600mm max
300mm min
POWER OUTLET
2. To adjust the rear height of the
appliance, turn the middle screw
counterclockwise.
13.2 Adjusting the level of the
appliance
A correct adjustment of the level of the
appliance allows the door to close and
seal correctly.
400mm
min
Min. 400 mm straight
section