Chapter 4 - Setting Up The Adsl Modem; Logging Into Your Adsl Modem; Figure 1-4 : Quick Start - Aztech DSL600E User Manual

Chapter 4 - Setting Up the ADSL Modem

This section will guide you through your ADSL Modem's configuration. The ADSL
Modem is shipped with a standard PPP configuration.
The basic tabs consist of features which are catered for basic users.
4.1

Logging into your ADSL Modem

To configure your ADSL Modem, open your web browser. You may get an error
message at this point; this is normal. Type the default IP address (192.168.1.1) or
login.modem on the web address bar.
NOTE: Before setting up your ADSL Modem, make sure you have followed
the easy start guide. You should have your computers configured for
DHCP mode and have proxies disabled on your browser. Upon
accessing the ADSL Modem, if the browser still displays a login
redirection screen, you should check your browser's setting and
ensure that the JavaScript support is enabled. If the screen shown in
Fig 1-4 is not attainable, you must delete your temporary Internet
files to clear the web cache.
Upon entering the default IP address or the short-cut name (login.modem), if the user is
logging for the first time, the user will be brought to the "Quick Start" page. See Fig 1.4.
The Quick Start page is meant for basic users whom only require easy connectivity to
the Internet without worrying about any other advance configuration setting. If you are in
doubt for what content to enter for the Protocol, VPI and VCI, please contact your
Service Provider for assistance.
ADSL2+ Ethernet Modem - User Guide

Figure 1-4 : Quick Start

Page 11 of 33