Advertisement
2. PARTS NAMES
The air conditioner consists of the indoor unit, the outdoor unit, the connecting pipe and the remote
controller. (See Fig.2)
■
Function indicators on indoor unit display panel
Temporary button
Operation lamp
PRE-DEF indicator(cooling and heating type) or fan only indicator(cooling only type)
Display panel
Temporary button
Operation lamp
Timer indicator
PRE-DEF indicator(cooling and heating type) or fan only indicator(cooling only type)
Display panel
This function is used to operate the unit temporarily in case you misplace the remote controller or its batteries
are exhausted. Two modes including AUTO and FORCED COOL can be selected through the TEMPORARY
BUTTON on the air-in grill control box of the indoor unit. Once you push this button, the air conditioner will run
in such order: AUTO, FORCED COOL, OFF, and back to AUTO.
1. AUTO
The OPERATION lamp is lit, and the air conditioner will run under AUTO mode. The remote controller
operation is enabled to operate according to the received signal.
2. FORCED COOL
The OPERATION lamp flashes, the air conditioner will turn to AUTO after it is enforced to cool with a wind
speed of HIGH for 30 minutes. The remote controller operation is disabled.
3. OFF
The OPERATION lamp goes off. The air conditioner is OFF while the remote controller operation is enabled.
NOTE
This manual does not include Remote Controller Operations, see the<<Remote Controller Owner's
manual>> packed with the unit for details.
Infrared signal receiver
Timer indicator
Fig.2-1
Infrared signal receiver
Alarm indicator
Fig.2-2
Alarm indicator
5
Advertisement
Chapters
