Configuration And Settings; Configuring The Ipc; Configuring The Sitop Psu8600 With Buf8600; Configuring The Hardware In The Tia Portal - Siemens SITOP PSU8600 Manual
Shutdown ipcs in the buffer mode
Hide thumbs
Also See for SITOP PSU8600:
- Manual (420 pages) ,
- Function manual (94 pages) ,
- Manual (70 pages)
Table of Contents
Advertisement
5 Configuration and Settings
Configuration and Settings
5
5.1
Configuring the IPC
Table 5-1
No.
1.
Connect the IPC to any 24 V voltage supply.
2.
Start the IPC.
3.
Open DiagBase via "Windows start button > All programs > Siemens Automation
> DiagBase > Management Explorer".
Click "? > About Management Explorer" in the menu in order to find out the in-
4.
stalled product version of DiagBase. With the help of chapter
the SIMATIC S7-1500 Software Controller on a IPC
has to be updated.
5.
If the SIMATIC S7-1507 Software Controller is not yet installed on your PC, install
it. The approach can also be found in the chapter mentioned in No. 4.
6.
Subsequently shut down the IPC again.
5.2
Configuring the SITOP PSU8600 with BUF8600
Table 5-2
No.
7.
Place the basic device and the buffer module next to each other on the DIN rail.
8.
Connect the modules with each other via the connector plugs/sockets on the top.
Insert the included cover on the open connection on the top of the buffer module.
Enable the remote access via the "REN" (remote enable) DIP switch on the front
9.
side of the basic device by sliding it to the right.
You can optionally enable the web server access via the "FUNC" DIP switch in the
same way
Note: For models with production state 2 and firmware 1.1.0 the name is "WEN"
(web server enable).
10.
Connect the 400 V voltage supply to the SITOP PSU8600 and make sure that the
voltage supply is not yet switched active.
5.3
Configuring the hardware in the TIA Portal
Table 5-3
No.
11.
Start the TIA Portal and go to the project view.
12.
Create a new project.
13.
Download the current support package for the SITOP PSU8600 and install it. An
instruction for can be found in chapter 3.2.
Click "Devices and network" in the project navigation to open the network view.
14.
15.
Move the IPC477D with article no. 6AV7240-yBxxx-xxxx to the network view,
using drag-and-drop via the hardware catalog "Industry PCs > SIMATIC Panel PC
> IPC477D > IPC 477D 15" Touch > IPC 477D 15" Touch PB".
Shutdown IPCs in the SITOP PSU8600 Buffer Mode
Entry ID: 109737962,
V1.2,
10/2017
Action
Basics for operation
you can find out whether it
Action
Action
19
Advertisement
Table of Contents
