De La Espada TABLE ONE Assembly Instructions Manual

ASSEMBLY INSTRUCTIONS
TABLE ONE BY MANUEL AIRES MATEUS
PARTS
1x Tabletop
2x Leg frames
2x Side beams
HARDWARE
(6x) Universal connector
(8x) M8x65 Caphead screw
YOU WILL NEED
-6mm Allen Key
-The help of 3 or 4 friends
NOTES
NOTE 1: Be certain that all assembly is carried out on a flat
and stable surface. This will ensure a good final result.
Reverse the steps to disassemble the piece.
NOTE 2: Your furniture arrives packed in numerous layers that
protect it during transport. It is important that you remove
the packaging carefully to avoid damaging your furniture. Refer
to our information sheet "Unpacking Your Furniture" for further
details.
NOTE 3: Great care is required when assembling our products.
Use blankets to soften the assembly surface - hard surfaces
such as wood or stone flooring may damage the furniture if in
direct contact.
NOTE 4: We advise that assembly and disassembly is undertaken
by a minimum of 4 people.
NOTE 5: When screwing in bolts, tighten well, but be sure
NOT TO OVERTIGHTEN. This can cause the thread to strip thus
resulting in a poor connection.
NOTE 6: While you work, be sure all connections are flush with
no gaps.
NOTE 7: After assembly, ensure that the table is resting on a
level surface.
(6x) Metal dowel
(8x) M8 Washer
SALES@DELAESPADA.COM
DELAESPADA.COM
0
1
M
A
N
U
E
L
A
I
R
E
S
M
A
T
E
U
S