Advertisement
ASSEMBLY INSTRUCTIONS
LIGHT EXTENDING TABLE BY MATTHEW HILTON
PARTS
1x Tabletop
2x Extension leaves
2x Leg frames
1x Cross beam
Hardware:
(4x) Universal connector
(8x) M8x40 bolts
(11x) washers
YOU WILL NEED
-6mm Allen Key
-The help of a friend
NOTES
NOTE 1: Be certain that all assembly is carried out on a flat
and stable surface. This will ensure a good final result.
Reverse the steps to disassemble the piece.
NOTE 2: Your furniture arrives packed in numerous layers that
protect it during transport. It is important that you remove
the packaging carefully to avoid damaging your furniture. Refer
to our information sheet "Unpacking Your Furniture" for further
details.
NOTE 3: Great care is required when assembling our products .
Use blankets to soften the assembly surface - hard surfaces
such as wood or stone flooring may damage the furniture if in
direct contact.
NOTE 4: We advise that assembly and disassembly of De La Espada
furniture is undertaken by a minimum of 2 people.
NOTE 5: When screwing in bolts, tighten well, but be sure
NOT TO OVERTIGHTEN. This can cause the thread to strip thus
resulting in A poor connection.
(4x) Metal dowel
(3x) M8x60 bolts
SALES@DELAESPADA.COM
DELAESPADA.COM
0
1
M
A
T
T
H
E
W
H
I
L
T
O
N
Advertisement
Table of Contents
Related Manuals for De La Espada LIGHT EXTENDING TABLE BY MATTHEW HILTON
Summary of Contents for De La Espada LIGHT EXTENDING TABLE BY MATTHEW HILTON
- Page 1 NOTE 4: We advise that assembly and disassembly of De La Espada furniture is undertaken by a minimum of 2 people. NOTE 5: When screwing in bolts, tighten well, but be sure NOT TO OVERTIGHTEN.
- Page 2 ASSEMBLY INSTRUCTIONS CONTINUED LIGHT EXTENDING TABLE NOTE 6: While you work, be sure all connections are flush with no gaps. NOTE 7: After assembly, ensure that the table is resting on a level surface INSTRUCTIONS 1. ATTACH LEGS TO THE CROSS BEAM a) Insert metal dowels into the holes on the side of the leg frames by screwing them in a clockwise direction until tight.
- Page 3 ASSEMBLY INSTRUCTIONS CONTINUED LIGHT EXTENDING TABLE 2) ATTACH LEGS AND CROSS BEAM TO TABLETOP Place the tabletop upside down a clean, soft surface such as blanket or carpet on the floor. Match the number on the leg frames with the number markings on the tabletop.
- Page 4 ASSEMBLY INSTRUCTIONS CONTINUED LIGHT EXTENDING TABLE 3) TURN THE TABLE INTO AN UPRIGHT POSITION With the help of a friend, carefully turn the table over into an upright position, taking care not to place any weight/force on the table legs while turning. Once the table is in an upright position, you can release the locking mechanism if desired.
- Page 5 ASSEMBLY INSTRUCTIONS CONTINUED LIGHT EXTENDING TABLE b) With the table fully open, place one or both extension leaves (as desired) into position, carefully connecting all guiding dowels with their corresponding holes. guiding dowels c) With the extension leaves in place, join the panels by push- ing the outer corners of the tabletops simultaneously, with the help of a friend.
- Page 6 ASSEMBLY INSTRUCTIONS CONTINUED LIGHT EXTENDING TABLE STORING THE EXTENSION LEAVES a) When desired, the extension leaves can be stored within the table as follows. One leaf should be placed face down into the fabric lined compartment. The other leaf should be placed face up on top of the first leaf, so the felt pads on the bottom of the two leaves meet.
Need help?
Do you have a question about the LIGHT EXTENDING TABLE BY MATTHEW HILTON and is the answer not in the manual?
Questions and answers