Table of Contents
Advertisement
1-5. Installation and Removal of Exterior Parts
3. Side Plate (Right)
(1) Turn off the power switch.
(2) Remove the front panel. (Refer to "1. Front Panel" in
this section.)
(3) Remove the eight screws (B4 x 5) and the rack angle.
(4) Remove the sixteen screws (PWH3 x 8, B4 x 5) and
the side plate (right).
Rack angle
PWH3 x 8
B4 x 5
(5) Install the side plate (right) in the reverse order of the
steps (1) through (4).
1-12(E)
Side plate (right)
B4 x 5
B4 x 5
B4 x 5
B4 x 5
4. Side Plate (Left)
w
Allow for more than five minutes interval after turning the
power off, remove the power unit.
To avoid shock hazards, never remove the power unit just
after turning the power off.
(1) Turn off the power switch.
(2) Remove the front panel. (Refer to "1. Front Panel" in
this section.)
(3) Remove the eight screws (B4 x 5) and the rack angle.
(4) Remove the four screws (PSW4 x 8) securing the
power unit.
(5) Hold the handles and pull out the power unit from the unit.
B4 x 5
Rack angle
(6) Remove the sixteen screws and the side plate (left).
Side plate (left)
B4 x 5
B4 x 5
B4 x 5
B4 x 5
B4 x 5
(7) Install the side plate (left) in the reverse order of the
steps (1) through (6).
Power unit
PSW4 x 8
Handles
FDDR-7000 IM
Advertisement
Table of Contents
