Powering On The Acme Packet 6300/6350; Initial Login - Oracle Acme Packet 6300 Hardware Installation And Maintenance Manual

You must connect to the console port on initial booting of the Acme Packet
2.
6300/6350.
If the Acme Packet 6300/6350 is already powered on, press the Enter key a few
3.
times to activate the console connection. When ACLI text is displayed on the
screen, the console connection has been successfully created.
If you have created the console connection before powering up the Acme Packet
4.
6300/6350, you can watch the boot process as it displays on your screen.

Powering On the Acme Packet 6300/6350

This section explains how to power on your Acme Packet 6300/6350.
Note:
There is a slight difference between the Acme Packet 6300 and Acme
Packet 6350 platforms in regards to powering on the system. The Acme
Packet 6300 has no ON/OFF switches, while the Acme Packet 6350 has a
System Power switch, which enables you to control the power to the system.
For more information on the Acme Packet 6350's System Power switch, see
Rear View.
To power on the Acme Packet 6300/6350 hardware:
Plug in the power cord. If you have the Acme Packet 6300, the power turns on
1.
and the system starts to boot. If you have the Acme Packet 6350, put the System
Power switch into the ON position and the power turns on and the system starts to
boot. For more information on the System Power switch, see Rear View.
When operating with redundant power supplies, both power supplies must be
2.
plugged in either simultaneously or within a few seconds of each other. Otherwise,
an alarm is generated.
The graphic display on the front control panel will begin to display information.
3.

Initial Login

Once you have established the console connection, powered on the Acme Packet
6300/6350 and a runtime image has been loaded, you are ready to log in and begin
configuring the system. After the Acme Packet 6300/6350 System has been initialized,
the ACLI login prompt appears in your terminal application as follows:
User Access Verification
Password:
If the Acme Packet 6300/6350 completed booting before you connected to the console
port, press the Enter key on the console keyboard a few times to activate the console
connection.
System access in the following procedure uses the default User and Superuser
passwords. If you do not have the default passwords, please contact your customer
support representative.
Powering On the Acme Packet 6300/6350
Chapter 5
5-2