Precautions Regarding; Electromagnetic Waves - Konica Minolta AeroDR SKR 4000 Operation Manual

CAUTION
• When using Image Storage, please pay attention to the
followings:
— Before performing an exposure operation, ensure
that the status LED of the DR Detector indicates that
it is standing by.
— After an exposure, do not give shocks and/or vibra-
tions to DR Detector for 6 seconds.
— Before performing an exposure operation, ensure
that the battery level of the DR Detector is more than
11 % level.
• When the radioactive substance remains in the patient's
body, e.g., after a nuclear medicine examination, the
system may recognize it as an X-ray exposure, trans-
mitting images.
• Please check that the LED indicates recharging status
when the Battery is inserted in the Battery Charger.
• Be careful not to get your hand caught when inserting
the Battery into the Battery Charger.
• If you use Ethernet cables, please pay attention to the
following.
— If the power of this device is on, do not connect nor
remove the Ethernet cables.
— Install the cables so that you do not catch them on
your feet and so on
— Do not apply a load
— Communication speed is low or communication is
down, it is necessary to check the Ethernet cable
replacement. Contact Konica Minolta technical repre-
sentatives.
• As the Battery is a consumable part, replace with a new
Battery when the operating time of the DR Detector be-
comes shorter.
• Remove the Battery when the DR Battery is not used
for a long period of time.
• While the network communication failure occurs, please
check if any of the conditions shown below is present:
— The operating system is not compatible.
— Software modification or update has failed.
— An interface compatibility error occurred
— A protocol error occurred in data transfer
— Data distortion occurred due to the interface or format
mismatch.
— Data output failed
• Please observe the notes below as image noise or arti-
fact may occur, or inaccurate image may be generated:
— Do not move the power cables during exposure.
— Do not use this device near a device that generates
strong magnetic field.
1�3�3

Precautions regarding

electromagnetic waves

EMC Statement
This device has been tested and found to comply with
the limits for medical devices in IEC 60601-1-2: 2014.
These limits are designed to provide reasonable pro-
tection against harmful interference in a typical medi-
cal installation. The device generates, uses and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to other devices in its vicinity.
However, there is no guarantee that interference will
not occur in a particular installation
Whether this device does cause harmful interference
to other devices can be determined by turning this
device off and on. If it causes harmful interference, the
user is encouraged to try to correct the interference by
1 or more of the following measures:
• Reorient or relocate the receiving device.
• Increase the separation between the devices.
• Connect this device into a wall outlet on a circuit differ-
ent from that to which the other devices are connected.
• Contact Konica Minolta technical representatives.
WARNING
• Do not use mobile RF communication devices such as
mobile phones or pocket pagers in the vicinity of this
device. Use of such RF devices near this device can
cause errors in operation due to electromagnetic wave
interference. When using a mobile RF device, ensure
that the distance between the RF device in use and this
device is at least 30 cm (12 inches).
• The use of accessories, transducers and cables other
than those sold by Konica Minolta, Inc. as internal
components, may result in increased emissions or de-
creased electromagnetic immunity of this device, pos-
sibly causing malfunction.
• Do not use this device adjacent to or stacked with other
devices. If adjacent or stacked use is necessary, con-
firm normal operation in the configuration in which this
device will be used.
Supplementary information regarding IEC
60601-1-2:2014
(1) Take precautions against this device especially re-
garding EMC. Install and put into service according
to the electromagnetic compatibility (EMC) infor-
mation provided in the manual (Table 1 - Table 2).
(2) This device is suitable for use in medical institutions
such as hospitals and clinics. However, this device
is not suitable for use in environments with high de-
gree of electromagnetic wave interference (such as
near an electric operation device in use for output,
or near a high frequency treatment device).
15
Safety precautions
1
2
3
4
5
6
7
8
9
10
11
12