Descaling The Evaporator Tank; Problem-Solving By The Installer; Disposal - Harvia Sentiotec Concept R CP-RCB-090 Instructions For Installation And Use Manual

Instructions for use for the user

7.6. Descaling the evaporator tank

Descale the evaporator tank as required. To do this, use a descaling agent for
by the manufacturer.
1. Prepare the descaling solution according to the manufacturer's instructions.
2. Fill the evaporator with the descaling solution up to the maximum mark.
3. Allow the descaling solution to boil for 10 minutes.
4. Wait until the descaling solution in the evaporator has cooled.
5. Place a receptacle under the ball valve at the bottom of the evaporator and
drain the evaporator tank.
6. Rinse the evaporator tank twice with tap water.

8. Problem-solving by the installer

Baking out of the heating rods
Moisture can accumulate in the heating rods in humid ambient conditions or dur-
ing long periods of non-use. This is a physical process and not a manufacturing
fault. Under certain circumstances, accumulation of moisture in the heating rods
can lead to the FI circuit breaker being triggered.
In this case, it is necessary to bake out the sauna heater under the supervision
of an electrician. To do this, the protective function of the FI circuit breaker must
be switched off. The baking out procedure takes approximately 10 minutes.
The safety function of the FI circuit breaker must subsequently be reactivated.
If the problem persists, consult your supplier.

9. Disposal

Please dispose of packaging materials in accordance with the ap-
plicable disposal regulations.
Used appliances contain reusable materials as well as hazardous
substances. Therefore, do not dispose of your used appliance with
household waste, but rather do so in accordance with the locally
applicable regulations.
p. 23/26
EN