Harvia Sentiotec Concept R CP-RCB-090 Instructions For Installation And Use Manual page 20

Instructions for use for the user
Filling the evaporator
CAUTION!
Risk of scalding
If you pour water into the hot evaporator tank, hot steam is created.
NEVER pour water into the hot evaporator tank.
mode.
If the overheating protection has switched off evaporator heating, or
if your sauna control unit reports a lack of water, allow the evapora-
tor to cool down BEFORE you pour water into the evaporator tank.
CAUTION!
Risk of scalding
If the evaporator tank is too full, boiling water will spray out of the evap-
orator tank.
1. Remove the ceramic bowl 1 and
the steam funnel 2.
2. Place a receptacle (at least 5 litres)
under the ball valve at the bottom
of the evaporator.
3. Turn the ball valve to the left until
4. When the evaporator tank 3 is empty,
close the ball valve.
5. Fill the evaporator tank 3 with fresh tap
water up to the maximum mark. You will need about 5 litres of water for
this. This amount of water allows the evaporator to be operated for ap-
proximately 1 hour.
6. Replace the ceramic bowl 1 and the steam funnel 2.
p. 20/26
1
2
3