SuperATV RWS-P-RZR900 Installation Instructions

Rear windshield for polaris rzr s 900

2753 Michigan Road • Madison, Indiana 47250 • 855-743-3427

- SuperATV does not recommend keeping Windshield installed while transporting on an open air trailer. Remove or

secure with straps.

- This item is not returnable if the protective film has been removed.

- Test fit to the cage to confirm fitment before removing film.

Rear Windshield

90° Bulb Seal

Need help with your installation?

sales@superatv.com

1-855-743-3427

(kit contents continue on following page)

www.superatv.com

8:00am - 8:00pm EST M-Th

8:00am - 7:00pm EST Friday

9:00am - 2:00pm EST Saturday

INSTALLATION INSTRUCTIONS

Rear Windshield

for Polaris RZR

Read instructions and view illustrations before beginning.

Thank You

S 900

For Choosing

Rev IN-RWS-P-RZR900 11/8/2016

Table of Contents

Need help?

Do you have a question about the RWS-P-RZR900 and is the answer not in the manual?

Page 1 ® 2753 Michigan Road • Madison, Indiana 47250 • 855-743-3427 - SuperATV does not recommend keeping Windshield installed while transporting on an open air trailer. Remove or secure with straps. - This item is not returnable if the protective film has been removed.
Page 2 The Buyer is also responsible to obey all ® applicable federal, state, and local laws and ordinances when operating his/her vehicle while using this product, and the Buyer agrees to hold SuperATV harmless from any ®...
Page 3 To ease installation, soak Bulb Seal in hot water face towards vehicle before cutting or installing to increase flexibility. install (1) piece of 90° Bulb Seal across top as shown install (1) piece of 90° Bulb Seal across bottom as shown IN-RWS-P-RZR900...
Page 4 - Install Clamps around Roll Bars. Clamp - Insert (1) Bolt and (1) Washer through each Bolt Rubber Grommet in Windshield. Washer - Use Nut to secure Windshield to Clamp. Install Clamps around Roll Cage If installed, pass Harnesses through Flap Seals in Rear Windshield (driver side) IN-RWS-P-RZR900...