TechniSat TechniMedia UHD Quick Start Manual page 23

process takes several seconds to complete.
6.1.2 Switching on from standby mode
Switch the TV on by pressing the On/Standby button on the remote control or on the
>
TV, or the Channel +/- keys on the remote control or on the TV, or a numeric key
between 0 and 9 on the remote control.
If the user-dependent parental lock (TechniFamily) outlined under point 10.9 of the
operating manual is activated, the user selection as per point 7.1.3 of the operating
manual will now be displayed.
6.1.3 Switching off to standby mode
Switch the TV off by pressing the On/Standby button on the remote control or on the
>
receiver.
Please note that the device's database is saved when switching off the device. This
process takes a few seconds. During this time the LCD display is already switched off.
After saving, the device switches fully to standby. The device is now in standby mode
and can be switched off at the mains.
6.1.4 Switching off using the mains power switch on the television
The television is switched off completely by pressing the mains power switch.
>
In this case neither automatic updating of the software and SFI data nor the recording
and alarm timers can be executed.
If a power failure occurs during operation, you should switch off the television using the
mains power switch so that it is not switched on again unintentionally as soon as the
power is available again.
You should only switch the television off from standby mode using the mains power
switch to prevent damage to the database.
23
EN
FR
IT