KNF SCC 950 Operating Instructions Manual page 34

Operating the vacuum pump system
34 Translation of original Operating Instructions, English, KNF 304771-304773 07/18
Calling the stored data point tables:

Press the button to select data point tables (arrow in Fig. 15)
and select the required data point table.
You can now see the data point table that is stored under the
number.
Up to 10 different data point tables can be stored and called as
required. The number in the display (arrow in Fig. 15) indicates
the data point table that is currently selected.
Paging the vacuum pump system
If the circle icon for the active process (Fig. 10/5, page 28) is
pressed on the hand terminal display, the LED beside the paging
button on the vacuum pump system flashes (Fig. 17, p. 36).
Likewise, the hand terminal responds to the paging button of the
vacuum pump system with a signal sound (see Chapter 8.2, page
36).
No wireless connection
If there is no wireless connection between the hand terminal and
the related vacuum pump system (for example if the vacuum pump
system is not switched on or the wireless connection is being
established or is interrupted):

The message "No connection" will flash in the hand termi-
nal's display (see Fig.16 );

an audible warning will be emitted if a button on the
touchscreen is pressed.
Refer to Chapter 10, Tab. 10 (page 49) for tips on resolving this
problem.
Fig.16 : Display "No connection"
Vacuum pump system SCC 950