KNF SCC 950 Operating Instructions Manual page 28

Operating the vacuum pump system
Displays
1 Battery:
- Charging
- Charging sta-
tus
2 Connection to vacuum
pump system
- Direct connection:
- Wireless connection:
3 Process time
4 Actual pressure in selected
pressure unit (or "No con-
nection" if there is no wire-
less connection to the vac-
uum pump system)
5 Process active
6 Capacity in percent or
setpoint pressure in select-
ed pressure unit (depend-
ing on operating mode)
7 Explanation of the rotary
knob functions
(Rotate: Change capacity;
Press: Interrupt operating
mode and switch to manual
process control)
8 Only in Automatic operating
mode
Automatic with pressure
reduction
9 Only in Automatic operating
mode
Automatic pressure reduc-
tion active
28 Translation of original Operating Instructions, English, KNF 304771-304773 07/18
into the charging station (Fig. 2/12); then firmly press the hand
terminal at the upper grip (Fig. 9/1) until it engages.
When the hand terminal is in the mounting on the operating
vacuum pump system, the batteries in the unit are charged
automatically. The batteries will charge even while the hand
terminal is switched off. The same applies if the charging
station is connected to the power supply via the power supply
unit.
Before each use of the hand terminal, confirm that the hand
terminal belongs to the desired vacuum pump system. The
paging function may be used for this purpose (see Paging the
vacuum pump system, page 34).
Fig. 10: Displays on the touchscreen
Vacuum pump system SCC 950