Auxiliaries And Accessories - LEGRAND DX3 Manual

STOP & GO automatic resetting STOP & GO automatic STOP & GO automatic STOP & GO automatic
5. GENERAL CHARACTERISTICS 5. GENERAL CHARACTERISTICS 5. GENERAL CHARACTERISTICS 5. GENERAL CHARACTERISTICS
Resistance to sinusoidal vibrations: Resistance to sinusoidal vibrations:
Resistance to sinusoidal vibrations: Resistance to sinusoidal vibrations:
. According to IEC 60068-2-6.
. Axis : x, y, z.
. Frequency range: 5÷100 Hz ; duration 90 min.
. Displacement (5÷13.2 Hz) : 1mm
. Acceleration (13.2÷100 Hz) : 0.7g (g=9.81 m/s
Maximum power consumption: Maximum power consumption: Maximum power consumption: Maximum power consumption:
. <20VA rms (<80VA peak) during resetting
Standby power consumption: Standby power consumption: Standby power consumption: Standby power consumption:
. <1,5VA
Recognition: Recognition: Recognition: Recognition:
. Labelling of the circuits by label in the "label holder" on the front-side of the device.
6. CON N N N FORMITIES AND APPROVALS 6. CO FORMITIES AND APPROVALS
6. CO 6. CO FORMITIES AND APPROVALS FORMITIES AND APPROVALS
Compliance with standard Compliance with standards s s s : : : :
Compliance with Compliance with standard standard
. CEE guidelines : 73/23/CEE + 93/68/CEE
. IEC / EN 50557: device for automatic reset of MCB's, RCBO's, RCCB's for household and similar purposes.
. Electromagnetic compatibility: EN 61543
. Legrand devices can be used under the conditions of use as defined by IEC / EN 60947.
7. 7. 7. 7. AUXILIARIES

AUXILIARIES AND ACCESSORIES

AND ACCESSORIES
AUXILIARIES AUXILIARIES AND ACCESSORIES AND ACCESSORIES
Signalling Signal Signal Signal ling ling ling auxiliaries: auxiliaries: auxiliaries: auxiliaries:
. Auxiliary contact (½ module – cat n° 4 062 58).
. Fault signalling changeover switch (½ module – cat n° 4 062 60).
. Auxiliary contact modifiable in default signal (½ module – cat n° 4 062 62).
. Auxiliary contact + fault signalling switch - can be modified to 2 auxiliary contacts (1 module - cat n° 4 062 66).
Control auxiliaries: Control auxiliaries: Control auxiliaries: Control auxiliaries:
. It is forbidden to associate control auxiliaries (cat. n° 4 062 7x / 8x) to motor driven control module with integrated automatic resetting.
Possible combinations with signal Possible combinations with
Possible combinations with Possible combinations with
. Auxiliaries are clipped on the left side of the Stop & Go unit
. Two signalling auxiliaries max. (cat. n° 4 062 58 / 60 / 62 / 66).
. If two signalling auxiliaries are associated to a same motor driven control unit, the 1 module wide control auxiliary (cat n° 4 062 66 / 78 / 82 / 84)
must be located to the left of the ½ module wide auxiliary (cat. n° 4 062 58 / 60 / 62).
Technical data sheet: F01284EN/00
resetting resetting resetting
(continued)
).
2
signalling ling auxiliaries: auxiliaries:
signal signal ling ling auxiliaries: auxiliaries:
Cat. N°(s) : 4 Cat. N°(s) : 4 062 88 / 89 062 88 / 89
Cat. N°(s) Cat. N°(s) : 4 : 4 062 88 / 89 062 88 / 89
Updated: - Created: 11/11/2011
5/5