Mounting The Kombitool; Fitting The Harness - Stihl SP-KM Instruction Manual

3
16 mm
1
Engage the combination wrench (3)
N
on the hexagon (4) at the base of
tine (1).
3
1
Use the combination wrench (3) to
N
tighten down the tine (1) firmly by
turning it another 30° to 40°.
Remove the combination wrench
N
from the tine.
SP-KM

Mounting the KombiTool

Push the lug (1) on the drive tube
N
4
into the slot (2) in the coupling
sleeve as far as stop.
2
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
Tighten down the star knob (4)
N
firmly.
Removing the KombiTool
Reverse the above sequence to
N
remove the drive tube.
2
1
3
4

Fitting the Harness

The type and style of the harness,
carrying ring and carabiner (spring hook)
depend on the market.
Shoulder Strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
English
1
9