Unpacking And Installation; Transport Considerations; Receiving Inspection; Required Tools - Fastcorp EVOLUTION FS-01 Setup And User Manual

To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | + 561-391-7200
TRANSPORT, UNPACKING AND INITIAL SETUP INSTRUCTIONS

TRANSPORT CONSIDERATIONS

The Evolution Vendor should always be maintained in an upright position.
Failure to do so may result in permanent damage to the vendor.
Whenever the Evolution Vendor is transported, always install the shipping
brackets that were provided with the machine. Replace cable ties as necessary.
Refer to the uncrating instructions for cable tie and shipping bracket installation.
ALL SHIPPING BRACKETS MUST BE REMOVED BEFORE APPLYING
POWER TO THE MACHINE. FAILURE TO DO SO MAY RESULT IN
PERMANENT DAMAGE TO THE ROBOT OR ELECTRONICS

RECEIVING INSPECTION

Upon Receipt, before removing packing material, inspect the outside of the
machine. Remove exterior packing materials. Inspect the vendor for shipping
damage. If possible, report shipping damage to the truck driver at the time of
delivery. Have the driver note damage on the bill of lading and immediately
notify the trucking company. Although the terms of sale are FOB shipping point,
which requires the consignee to initiate shipping damage claims, Fastcorp will
gladly help if a claim needs to be filed.
Tools required to uncrate the vendor:
Screw gun with Phillips #2 bit, box cutter knife, 1 3/8-inch socket wrench,
5/16-inch socket wrench or nut driver, 7/16-inch socket wrench, cutting
pliers
The Evolution Merchandiser is packaged using the most effective means
possible to safeguard the vending machine during transportation and distribution.
We encourage you to save the shipping materials for reuse whenever the vendor
is shipped.
The cabinet is shrink-rapped after the installation of:
• (4) Corner Boards
• Bubble Wrap
• Card Board Panels
This serves to protect the graphics and prevent damage to the cabinet and door.
!! ATTENTION !!
- 12