5-4.Using Scsiselect Settings - NEC N8103-107 User Manual

5-4.Using SCSISelect Settings

To select an option, use the arrow keys to move the cursor to the option, then press <Enter> key.
In some cases, selecting an option displays another menu. You can return to the previous menu at
any time by pressing <Esc> key.
Tips
Configure/View SCSI Controller Settings
Various settings for this product can be changed using "Configure/View Host Adapter Settings".
Option
SCSI Bus Interface Definitions:
SCSI Controller ID
SCSI Controller Parity
SCSI Controller Termination
Additional Options:
Boot Device Configuration:
Select Master SCSI Controller
SCSI Device Configuration:
Sync Transfer Rate (MB/sec)
Paketized
QAS
Initiate Wide Negotiation
Enable Disconnection
Send Start Unit Command
BIOS Multiple LUN Support
Include in BIOS Scan
Advanced Configuration:
Reset SCSI Bus at IC Initialization
Display <Ctrl><A> Message During BIOS Initialization
Extended INT 13 Translation for DOS Drivers > 1 Gbyte
POST Display Mode
SCSI Controller Int 13 Support
Domain Validation
Support Removable Disks Under Int 13 as Fixed Disks
BIOS Support for Bootable CD-ROM
To restore the original SCSISelect default values, press <F6> form the
"Configure/View SCSI Controller Settings" menu.
Available Settings
0 - 15
Enabled,
Disabled
Automatic, Disabled
29320LPE
320, 160, 80.0, 66.6,
40.0, 33.3, 20.0, 10.0,
ASYN
Yes, No
Yes, No
Yes, No
Yes, No
Yes, No
Yes, No
Yes, No
Enabled, Disabled
Enabled, Disabled
Enabled, Disabled
Verbose, Silent,
Diagnostic
Enabled,
Disabled:NOT scan,
Disabled:scan bus
Enabled, Disabled
Boot Only,
All Disks,
Disabled
Enabled, Disabled
- 44 -
Default Value
7
Enabled
Automatic
29320LPE
320
Yes
Yes
Yes
Yes
Yes
No
Yes
Enabled
Enabled
Enabled
Verbose
Enabled
Enabled
Disalbed
Enabled