Dial Modifiers - eLine ELC-576ET Manual

Enables or disable data compression negotiation. The modem can only perform data compression on an
error-corrected link.
%C0 Disables data compression.
%C1 Enables V.42bis/MNP 5.(Default)

4.2 Dial Modifiers

This section describes all of the dial modifiers that are used in dial strings.
@ Answer
"@", placed after a phone number, this modifier tells the modem to wait for 5 seconds of
silence before dialing the next number in the dial string. @ is usually used to access a secure
computer system that provides a silent answer as permission for further entrance.
, Pause
",", placed anywhere in the dial string, tells the modem to pause for the number of seconds
specified by S-register S8 before processing the rest of the dial string.
! Initiate a Hookflash
"!", placed anywhere in the dial string, tells the modem to initiate a hookflash, which means to
hang up for 0.5 seconds and then go off-hook again before processing the rest of the dial
string. This modifier allows access to PBX features like call transferring .
; Return to Command State after Dialing
";", which must be placed at the end of the dial string, returns to the command state after
dialing the number placed ahead of it. A long telephone number would overflowthe 40
character command buffer if placed all in one command line, so it must be broken into two or
more command lines. Each part includes part of the number, and all but the last command
line end with the ";" followed by a carriage return.
^ Tone Control
Toggles calling tone enable/disable:applicable to current dial attempt only.
P Pulse Dialing
P, placed ahead of a number, tells the modem to dial a number using pulse dialing.
S Dial a Stored Number
S is used to dial one of four numbers stored in nonvolatile memory. For example, instead of entering a
dial string, you can use this command: