Table of Contents
Advertisement
contained in the following section. The D command without a dial string is usually used to
switch from voice conversation to data communication or to call a remote modem in leased-
line operation mode.
En
Command Echo
E0/E
Disables command echo.
E1
Enables command echo. (Default)
Hn
Hang Up
H0/H
Goes on-hook. (hangs up)
H1
Goes off-hook. (ready to dial)
In
Identification
I0/I
Report the product code.
I1
Report the hardware checksum.
I2
Report " NVRAM Test Result ".
I3
Report "TP560 Data/Fax/Voice 56K Modem).
I4
Report Firmware Version.
I5
Report the country code parameter.
I6
Report Local Phone Status.
Ln
Control Speaker Volume
L0/L
Low volume.
L1
Low volume.
L2
Medium volume. (Default)
L3
High volume.
Mn
Monitor Speaker On/Off
M0/M
Speaker is always off.
M1
Speaker is off while receiving carrier. (Default)
M2
Speaker is always on.
M3
Speaker disabled while dialing.
Nn
Automode Enable
N0/N
Automode detection is disabled.
N1
Automode detection is enabled.(Default)
On
Return to On-Line Data Mode
Advertisement
Table of Contents
