eLine ELC-576ET Manual page 21

*I14 Selects connect speed 45333bps
*I15 Selects connect speed 46666bps
*I16 Selects connect speed 48000bps
*I17 Selects connect speed 49333bps
*I18 Selects connect speed 50666bps
*I19 Selects connect speed 52000bps
*I20 Selects connect speed 53333bps
*I21 Selects connect speed 54666bps
*I22 Selects connect speed 56000bps (Dafault)
*Gn User Abort Selection
*G0/*G
*G1 Disables key abort feature.
*Hn Auto Retrain Selection
*H0/*H Disables auto retrain
*H1 Enables auto retrain.(Dafault)
4.1.3 Commands Preceded by \
Operation Mode Control
\Nn
Selects the operating mode to be used during connection
\N0 Selects Normal (speed buffering) Mode.
\N1 Selects Direct (pass-through) Mode.
\N2 Selects MNP or disconnect mode.
\N3 Selects MNP or Buffer.
\N4 Select V.42 without ODP&ADP phase detection, MNP or buffer.
\N5 Select V.42 with ODP&ADP phase detection, MNP or buffer.(Dafault)
\N6 Select V.42 without ODP&ADP or disconnect.
\N7 Select V.42 with ODP&ADP or disconnect.
\Vn Single Line Connect Message Enable
The single line connect message format can be enabled or disabled by the \Vn command as follows:
\V0 Disable protocol result code appended to DCE speed. (Default)
\V1 Eisable protocol result code appended to DCE speed.
4.1.4 Commands Preceded by %
%C Enable/Disable Data Compression
Enables key abort feature.(Default)