eLine ELC-576ET Manual page 17

O0/O Enters on-line data mode without a retrain. Handling is determined by the Call
Establishment task. Generally, if a connection exists, this command connects the
DTE back to the remote modem after an escape (+++).(Default)
O1 Enters on-line data mode with a retrain before returning to on-line data mode.
O2 Enters on-line data mode with a rate re-negotiation before returning to on-line data
mode.
P Set Pulse Dial as Default
Causes the modem to assume that all subsequent dial commands are pulse dials. You may
omit the " P " from the dial strings.
Q Result Code Display
Determines whether the modem sends the result codes to the DTE.
Q0/Q Enables result codes to the DTE (Default).
Q1 Disables result codes to the DTE.
T Set Tone Dial as Default
Causes the modem to assume that all subsequent dial commands are tone dial.
Vn Select Word or Digit Result Codes
V0/V Displays result codes in digital format.
V1 Displays result codes in verbose format. (Default)
W Connect Message Control
This command controls the format of CONNECT messages.
W0/W Upon connection, the modem reports only the DCE speed (e.g., CONNECT 19200).
Subsequent responses are disabled.
W1 Upon connection, the modem reports the line speed, the error correction protocol,
and the DTE speed, respectively. Subsequent responses are disabled.
W2 Upon connection, the modem reports the DCE speed (e.g., CONNECT 14400).
Subsequent responses are enabled.(Default)
W3 Upon connection, the modem reports the line speed, the error correction protocol,
and the DTE speed, respectively. Subsequent responses are enable.
Xn Extended Result Codes
This command selects which subset of the result messages will be used by the modem to
inform the DTE of the results of commands.
Blind dialing is enabled or disabled by country parameters. If the user wishes to enforce dial
tone detection, a "W" can be placed in the dial string(see D command). Note that the
information below is based upon the default implementation of the X results table.