Table of Contents
Advertisement
&G2
Select 1800Hz-guard tone.
&Kn
DTE/Modem Flow Control
Determines how the modem controls the flow of data between the local DTE and the modem. When the
modem terminal buffer is nearly full, the modem will either send an XOFF or drop CTS to stop the data
flow. When the buffer is nearly empty, the modem will either send an XON or raise CTS to start the
data flow.
&K0/&K
Disable DTE/DCE flow control.
&K3
Enable RTS/CTS DTE/DCE flow control. (Default)
&K4
Enables XON/XOFF DTE/DCE flow control.
&K5
Enable RTS/CTS and transparent XON/XOFF DTE/DCE flow control.
&Pn
Select Pulse Dial Make/Break Ratio
&P0/&P
Sets a 39/61 make/break ratio @ 10 pps. (Default)
&P1
Sets a 33/67 make/break ratio @ 10 pps.
&P2
Sets a 39/61 make/break ratio @ 20 pps.
&P3
Sets a 33/67 make/break ratio @ 20 pps.
&Rn
CTR Signal Select
Determines whether CTR operates in accordance with the EIA-232-D specification or remains ON
&R1/&R
CTR will become active when RTS is On.
&R0
CTS is always ON. (Default)
&Sn
DSR Option
Determines whether DSR operates in accordance with the EIA-232-D specification or remains ON
&S0/&S
DSR is always ON. (Default)
&S1
DSR will become active after answer tone has been detected and inactive after the carrier
has been lost.
&Un
Protocol Selection
&U0/&U
V.90 mode.(Default)
&U1
V.34 mode.
&U2
V.32bis/V.32/V.22bis mode.
&U3
Bell 103 300bps mode.
&U4
V.21 300bps mode.
&U5
V.23 mode.
&V
View Configuration Profiles
&V
Displays the active configuration profile.
Advertisement
Table of Contents
