Fan Button; Swing Button; Sleep Button - Whirlpool SPIW409A2WF Instructions For Use Manual

Remote controller
Function description of buttons (J1-3A)
1. ON/OFF BUTTON
Starts or Stops the appliance by pressing this button.
2. MODE BUTTON
Used to select the operation mode in sequence of
Cooling, dry, fan only or heating.

3. FAN BUTTON

Used to select fan speed in sequence auto, high,
medium or low.
4-5. TEMPERATURE BUTTON
Used to select the room temperature. Used to set
time in timer mode and real time clock.
6. 6 SENSE BUTTON
TH
Sets or cancels 6
th

7. SWING BUTTON

Stops or starts horizontal adjustment louver swinging
and sets the desired up/down airflow direction.

8. SLEEP BUTTON

Sets or cancels Sleep Mode operation in sequence
of sleep 1, sleep 2, sleep 3, sleep 4 or sleep off.
9. AROUND U BUTTON
Used to set or cancel Around U function.
10. TIMER ON/CLOCK BUTTON
Used to set the current time.
Used to set or cancel the timer on operation.
11. TIMER OFF BUTTON
Used to set or cancel the timer off operation.
12. JET BUTTON
Used to start or stop the fast cooling or heating mode.
Symbols on RC display
Cooling indicator
Dry indicator
Fan only indicator
Heating indicator
6 Sense indicator
th
PROTECTION
Operating condition
The protective device maybe trip
and stop the appliance in the cases
listed below.
Outdoor air temperature
is over 24°C
Outdoor air temperature
Heating
is below -7°C
Room temperature is
over 27°C
Outdoor air temperature
is over 43°C
Cooling
Room temperature is
below 21°C
Room temperature is
Dehumidifying
below 18°C
If the air conditioner runs in
COOLING or DRY mode with door
or window opened for a long time
when relative humidity is above 80%,
dew may drip down from the outlet.
sense operation.
Sleep 1 indicator
Sleep 2 indicator
Sleep 3 indicator
Sleep 4 indicator
Around U indicator
Features of protection device
Wait at least 3 minutes before
restarting the unit after operation
stops or changing mode during
operation. After connecting to
power supply and turning on the
appliance immediately, a delay of 20
seconds may occur before it starts to
operate. If all operation has stopped,
press ON/OFF button again to
restart. Timer should be set again if
it has been cancelled.
Features of COOLING mode
Anti-freezing
When the temperature of the indoor
heat exchanger drops to 0° or
below, compressor will stop working
to protect the appliance.
q
e
w
u
y
a
h
13. DIM BUTTON
Used to turn on or turn off display light on indoor
unit.
14. POWER SAVE BUTTON
Used to start or stop the power save operation.
15. SUPER SILENT BUTTON
Used to start or stop the super silent operation to
have a low noise environment.
Auto fan speed
High fan speed
Medium fan speed
Low fan speed
Super silent indicator
- 10 -
r
t
i
d
f
o
g
s
Jet indicator
Signal transmission
Display set timer
ON
OFF
Display current time
Display set temperature
Power save indicator
Features of HEATING mode
Preheating
In order to prevent cool air blowing,
2-5 minutes are necessary to
preheat the indoor unit at HEATING
operation start. The indoor fan will
not work during preheating.
Defrosting
In HEATING operation the appliance
will defrost (de-ice) automatically
to raise efficiency. This procedure
usually lasts 6-10 minutes. During
defrosting, fan stops running and
running indicator flashes.
After defrosting is completeed,
it returns to HEATING mode
automatically.