Table of Contents
Advertisement
Product Information
Handpiece
No.
name
1
Test horn
2
Protector sleeve
3
Tip holder
4
One piece tool (M6 x 0.9) The One piece tool (M6 x 0.9) is used directly on the handpiece.
1
2
A test horn is installed at the end of the handpiece at the factory.
This test horn is used to check if the ultrasonic vibration is
properly output from the handpiece. When using the handpiece,
remove the test horn and install the No. 3 and No. 4 tools before
use.
The protector sleeve prevents direct contact with the tool
connection. Always make sure that the protector sleeve is
installed before using the handpiece, as using the handpiece
without it may result in burns.
This is the holder to which the special tip tool is attached.
3
4
Note
32
Advertisement
Table of Contents
