Table of Contents
Advertisement
4
How to use
4 – 1
Basic Operation
3
2
4
Startup / Stop
4
You can start and stop the program in one of the following two ways
(1) Manual ON / OFF
Press the ON / OFF key to activate
and Stop.
If it is started by the ON / OFF key, it can only be
stopped by the ON / OFF key.
The ON / OFF key and the LED on the handpiece light up when starting up.
As long as the LED is on, it is vibrating.
Power off
5
When using the tip holder, be sure to use it in CLAMP mode.
When using the One piece tool , it can be used in UNCLAMP or CLAMP mode (low power).
The thread of the One piece tool is M6 x 0.9. Do not install screws of different size.
Setting the WATT display (see "6 – 4 Setting the amplitude display and WATT Display."), use 8W or less for
continuous use.
Using the handpiece at high power can cause the tool and tip holder to become very hot, which can cause
handpiece failure and injury.
Do not plug or unplug the handpiece and foot switch while the foot switch is depressed. Failure to do so may
result in failure or malfunction.
1, 5
1
Power ON
The LED on the control panel lights up.
2
Mode Selection
The LED of the selected key lights up.
3
Power level adjustment
Press and hold down the key
to activate the key repeat function.
(2) When using the foot switch
It is activated by pressing the
pedal.
Release the pedal to stop.
(See "6 – 5 Setting the foot switch")
If activated by a footswitch, it can only be stopped
by a footswitch.
CAUTION
36
UNCLAMP mode
CLAMP mode
UP key
DOWN key
Advertisement
Table of Contents
