Nakanishi Sheenus ZERO Operation Manual

Operation Guide
See attached operation manual
for details.
DOWN key
Reduce
the power level.
CLAMP key
Main power switch
1
Power ON:
Press [Main power switch]
The LED on the control panel lights up.
2
Mode selection:
The LED of the selected key lights up.
CLAMP mode (low power)
■
for ceramic fiber grindstone
(also used for one piece tool)
3
Power level adjustment:
Displays the power level.
(Can be adjust during vibrating)
4
Startup:
Press [ON / OFF key] or use the foot switch
The ON / OFF key and the LED on the
handpiece light up when starting up.
Ultrasonic Polisher
Select [CLAMP key] or [UNCLAMP key]
Press [DOWN key] or [UP key]
DOWN key
700 Shimohinata, Kanuma, Tochigi 322 - 8666, Japan TEL: +81 289 64 3520 FAX: +81 289 62 1135
UNCLAMP mode
■
for electroplated diamond file
(One piece tool)
When using the foot switch
• Factory default setting: Pressing the foot switch to start
and releasing it to stop.
• The setting can be changed to pressing the foot switch
to start and pressing it again to stop. See attached
operation manual to check how to change the setting.
If it is activated by a foot switch, it can only be stopped by a foot
switch. See reverse side for connecting.
UP key
Increase
the power level.
UNCLAMP key
ON / OFF key
Start and stop
the handpiece.
UP key
PR-K350E Ver.1 '20.09.XX.N