VTech LS6425 User Manual page 60

Appendix
No battery
No line
No signal,
call ended
Not available at
this time
Number already saved
Out of range OR
No pwr at base
** Paging **
Phone
Place in charger
Rec mem full
Rec mem low
Ringer muted
Ringer off
Saved
Speaker
Unable to call.
Line in use
Unable to call.
Try again
Unable to save
XX Missed calls
XX New messages
No battery is installed. Follow the directions for battery
installation on page 3 to install the battery before charging.
There is no telephone line connected.
Communication between the handset and telephone base
is lost during a call.
One handset is already viewing the caller ID log or
directory, and another handset attempts to review it.
You attempt to place a PTT call to another handset which
is on an outside call or intercom call, or accessing the
answering system.
The telephone number entered is already stored in the
directory.
The handset cannot communicate with the telephone
base. Check the telephone base power connection or
move closer.
The system handset is being paged.
The handset is on a call.
The battery is very low. Place the handset in the
telephone base or charger for recharging.
The answering system memory is full
The answering system has less than three minutes of
recording time left.
The ringer is muted temporarily during an incoming or
intercom call.
The ringer is turned off.
Your selection has been saved.
The handset speakerphone is in use.
You are attempting to predial a number while the
telephone line is in use.
You try to join a call when there are already four handsets
on that call, or to make an outside call when another
handset is transferring a call with the intercom feature.
You are attempting to save a caller ID entry without a
name and number into the directory.
There are XX calls that have not been reviewed in your
caller ID log.
There are XX new messages in the answering system.
56