Checking Gear Box Oil Level - Kubota ZG332 Operator's Manual

BChecking Gear Box Oil Level
To avoid personal injury:
A Always stop the engine and remove the key
before checking oil.
If serial numbers of mower are as indicated below
RCK60P-327Z:40000 and below
RCK72P-332Z:20000 and below
1. Park the machine on a flat surface and lower the
mower to the ground.
To check the oil level, loosen the check plug and check
to see if the oil level is in the range of the check plug
port.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
2. After checking, reinstall the check plug and oil inlet
plug securely.
(1) Drain plug
(2) Check plug
(3) Oil inlet plug
(4) Gear case
(5) Check plug port
(A) Oil level is acceptable within
this range.
(B) Oil level
PERIODIC SERVICE
If serial numbers of mower are as indicated below
RCK60P-327Z:40001 and above
RCK72P-332Z:20001 and above
1. Park the machine on a flat surface and lower the
mower to the ground.
To check the oil level, loosen the oil inlet plug with
gauge, wipe it clean, reinstall it and loosen it again.
Check to see if the oil level is between the notch and
tip.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
2. After checking, reinstall the oil inlet plug with gauge
securely.
(1) Drain plug
(2) Oil inlet plug with gauge
(3) Seal washer
(4) Gear case
51
(A) Oil level is acceptable within
this range.
(B) Oil level