Checking Tire Pressure; Checking Transmission Fluid Level - Kubota G23-2 Operator's Manual

50 PERIODIC SERVICE
A Be sure to reinstall the panel on the pillar completely
to prevent the invasion of dust.
A Be sure to stop the engine to avoid personal injury and
to allow good air intake for air cleaner.
BChecking Tire Pressure
To avoid personal injury:
A Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
A Always maintain the correct tire pressure.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
A Inflation pressure in front tires rises quickly
when using compressed air.
Never operate machine with a loose rim, wheel, or
axle.
A Whenever bolts are loosened, retighten to
specified torque.
A Check all bolts frequently and keep them
tightened.
C Inflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it everyday and inflate as necessary.
Tire sizes
16 x 7.50 - 8,
Front
Turf
24 x 12.00 - 12,
Rear
Turf
Recommended Inflation
Max. Pressure
120 kPa
(1.2 kgf/cm )
100 kPa
(1.0 kgf/cm )
(1) Ground
BChecking Transmission Fluid Level
1. Park the machine on a flat surface, raise the mower
and lower the grass catcher and shut off engine.
2. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
(1) Oil inlet
(2) Dipstick
A If oil level is low, do not run the engine.
(A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
(A) Oil level is acceptable within
this range.