Replacing Bulbs; Checking And Replacing Blade - Kubota G23-2 Operator's Manual

C Protected circuit
FUSE
SYMBOL CAPACITY(A)
NO.
(1) 10
(2)
15
(3) 15
(4) 10
(5) 15
(6) 15
(7) 15
(8) 10
CAPACITY (A)
Slow blow Fuse (50A)
BReplacing bulbs
Head lights:
Take the bulb out of the light body and replace with a new
one.
Light
Headlights
Protected circuit
POSITION LIGHT
(PARKING)
SOLENOID
(ENGINE STOP)
HAZARD LIGHT
ACC
HORN
BEACON
HEAD LIGHT
BRAKE LIGHT
Protected circuit
Check circuit against
wrong battery connection
Capacity
40W / 50W
PERIODIC SERVICE
BChecking and Replacing Blade
To avoid serious injury:
A Be sure to stop the engine and remove the key.
A Blades may be sharp. When you handle blades,
wear heavy gloves or wrap end of blade with a
rag.
C Checking
The blade cutting edges should be kept sharp at all times.
Sharpen the cutting edges, if they resemble blade (B).
Replace the blades if they appear similar to blade (C).
C Replacing
1. Remove the mower deck from the machine.
2. Remove the two snap pins and the shaft, and then
remove the mower duct with sliding it.
(1) Mower duct
(2) Snap pin
(3) Shaft
77
(A) New blade
(B) Worn blade
(C) Cracked blade
(A) "SLIDE"