Hayter LT322 Instruction Manual And Parts List page 15

1.15
ASSEMBLY
Continued.
7. Open the engine cover and remove the side screens.
8. Remove the tool box assembly from the L.H. side of the machine. Discard the fasteners securing the tool box brackets
to the chassis. Drill out the two chassis mounting holes on the front tool box bracket to diameter 10.5mm.
9. Remove and discard the rearmost fuel tank mounting fasteners on each side of the machine. (For early LT322 and
LT324 Turf Mowers, refer to page 1.20).
10. Locate the backing plates (items 10, 11, 15) to the holes on the inside of the chassis members as shown in fig. 3.
11. Secure the rear L.H. cab support (item 3) to the six positions in the chassis using fasteners (items 12,13 &14). Refer
- fig. 3. Do not fully tighten at this stage.
12. Repeat (step 11) for the rear R.H. cab support and reassemble the tool box as described in step '13'.
fig. 3.
13. Use the M8 fasteners (items 28, 29, 30, 31) to secure the rear tool box bracket in the new position on the R.H. side
of the machine and ensure that 3 washers (items 30) are assembled together at the 2 fixing positions as shown. Refer
- fig. 4.
Note: If a lighting kit is fitted, discard the fasteners securing the light cluster at the rear of the machine. Re-secure
between the chassis and the rear tool box bracket and eliminate 2 of 3 washers referred to above at the 2 fixing
positions .
Fit the front tool box bracket with fasteners (items 12, 13, 14) which are used to secure the rear of the R.H. Cab
support. Refer - fig. 4.
CAB GENERAL ASSEMBLY
1.15