Introduction; Removing The Bezel From The Dispenser - Wayne Vista Series Service

Blending and non-blending suction pumps and remote dispensers

Table of Contents

B.1.

INTRODUCTION

This Appendix describes in detail the troubleshooting of the various electronic and

electrical components used in Vista series blending and non-blending dispensers (see

Figure B-1 for a typical Vista dispenser). All electronic components discussed in this

section are located in the dispenser electronic head. The blend motor, one electrical

component discussed here, is located in the dispenser junction box.

Bezel

B.2.

In order to test the electronic components you must first remove the bezel from the dispenser.

To remove the bezel from the dispenser perform the steps shown in Figure B-2.

Warning:

The following actions require that the electrical power to the equipment be on.

Remember that electrical power is dangerous and proper precautions to pro-

tect oneself from contact with the electrical power are necessary.

November 1992

Total

Gallons

REGULAR

PLUS

FIGURE B-1. TYPICAL VISTA DISPENSER

Main Sale Display

Unit Price Display

"Push-to-Start" Bar

SUPER

Ad Panel

Nozzle Boot

Part No. 917543 Rev. A

Table of Contents