Setting A Fueling Point - Wayne Vista Series Service

Blending and non-blending suction pumps and remote dispensers
Table of Contents

Advertisement

2.2.2.
Authorize Switch, continued
2.2.3.
Setting A Fueling Point (Pump Number)
In order to set unit prices, or to authorize a dispenser, from a control system
each fueling point must be assigned an individual I.D. number. A fueling
point is defined as any location at which a customer can stop and dispense
fuel. In general, each Duplex II Computer in a dispenser represents two
fueling points.
The fueling point number is set as follows:
Note:
In order for the dispenser to operate each fueling point must be set to a unique
number other than zero.
10
Part No. 917543 Rev. A
An optional Local Authorize keyswitch may be installed on the outside of
the dispenser; this switch may be used as a one time authorize by moving
it to the full service position and back to the self service position (operat-
ing levers must be OFF; turn the keyswitch clockwise then back counter-
clockwise). The dispenser will operate one time following this sequence.
Programming in the control system will determine the use of the Authorize
switch when the dispenser is under console control.
The Position Select pushbutton is used to enter the fueling point setting
mode. The Totals pushbutton sets the fueling point number; see Figure 2-
1 for switch location.
Press the Position Select pushbutton.
To read the fueling point number, press and release the Totals switch.
To set the fueling point number, press and hold the Totals pushbutton. The
least significant digit of the unit price display will cycle 0 through 9.
Release the Totals pushbutton when the correct number is displayed.
Press and hold the Totals pushbutton again and the next significant digit
will cycle 0 through 9. Release the Totals pushbutton when the correct
number is reached. Currently only the numbers 01 through 24 are valid
fueling points. If any other number is entered the control system will not
communicate with the dispenser computer.
Press the Position Select pushbutton until the original sale display returns.
November 1992

Advertisement

Table of Contents
loading

Table of Contents