Adjusting The Height-Of-Cut; Positioning The Seat; Adjusting The Motion-Control Levers - Toro TimeCutter ZS 4200S Operator's Manual

Adjusting the Height-of-Cut

Height-of-cut is controlled by the lever located to the right of
the operating position (Figure 21).
2
1. Height-of-cut lever
2. Height-of-cut positions
1. Pull up and inward on the lever to move it to the
desired cutting position.
2. Once at the desired cutting position, slowly lower the
lever until it engages the position.
Note: The transport position is the highest height-of-cut
position or cutting height (115 mm (4.5 inches)) as shown
in Figure 21.
3
1
G015319
Figure 21
3. 115 mm (4.5
inches)—transport
position

Positioning the Seat

The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
1. Raise the seat and loosen the adjustment bolts just
enough that seat can move (Figure 22).
1
1. Adjustment bolt
2. Move the seat to the desired position and tighten the
bolts.
Adjusting the Motion-control
Levers
Adjusting the Height
The motion-control levers can be adjusted higher or lower for
maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control-arm shaft (Figure 23).
2. Move the control lever to the next set of holes.
3. Secure the lever with the 2 bolts (Figure 23).
G014970
1. Control-arm shaft
2. Control lever
21
G014477
Figure 22
2
1
3
4
Figure 23
3. Slotted, upper hole
4. Bolt