Stopping The Machine - Toro TimeCutter ZS 4200S Operator's Manual

WARNING
Removing your hands from the motion-control
levers while the machine is in motion can
result in a loss of control causing harm to you
or bystanders.
Always stop the machine and move the
motion-control levers to the park position
before adjusting the Smart Speed™ Control
System.
2. Adjust the lever to the desired position.
Driving Forward
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion-control levers
forward (Figure 17).
Figure 19
To go straight, apply equal pressure to both
motion-control levers (Figure 17).
To turn, release pressure on the motion-control lever
toward the direction you want to turn (Figure 17).
The farther you move the motion-control levers in
either direction, the faster the machine will move in
that direction.
To stop, pull the motion-control levers to neutral.
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, look behind you and down, as you
slowly pull the motion-control levers rearward (Figure
20).
To go straight, apply equal pressure to both
motion-control levers (Figure 20).
To turn, release the pressure on the motion-control
lever toward the direction you want to turn.
To stop, push the motion-control levers to neutral.

Stopping the Machine

To stop the machine, move the motion-control levers to
neutral and outward to the park position, disengage the
blade-control switch, ensure the throttle is in the Fast
position, and turn the ignition key to off.
G008952
Note: Remember to remove the key from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion-control levers outward to the park position
when leaving the machine unattended, even if just
for a few minutes.
20
G008953
Figure 20