Toro TimeCutter ZS 4200S Operator's Manual page 39

2
3
4
Figure 54
Mower decks with 3 Blades
1. Blades side to side
2. Sail area of blade
5. Measure between the outside cutting edges and the flat
surface (Figure 53 and Figure 54).
Note: If both measurements are not within 5 mm
(3/16 inch), an adjustment is required; continue with
this procedure.
6. Support the weight of mower deck by placing wood
blocks under the edges of the mower deck.
Note: Avoid placing the supports under any anti-scalp
rollers if present on the mower deck.
7. Move to the left side of the machine.
8. Check if the side carriage bolt is in the fixed or slotted
position (Figure 55).
Note: If the side carriage bolt is in the fixed position,
remove the side carriage bolt and the side-locking
nut from the fixed position, and install it into the
slotted-adjustment position (Figure 55).
Note: If the bolt is in the slotted position, the carriage
bolt and side locking nut do not need to be removed.
G005278
3
1
2
4
3. Outside cutting edges
4. Measure from the tip of the
blade to the flat surface
here
5
4
1. Hanger bracket
2. Slotted-adjustment
position
3. Fixed position
9. Loosen the rear locking nut on the hanger bracket
(Figure 56).
3
4
1. Hanger bracket
2. Rear locking nut
10. Loosen the side locking nut on the hanger bracket just
enough to allow the hanger to be adjusted (Figure 56).
11. Use the notches on the welded bracket to measure the
amount of adjustment.
Note: Each notch surface is equivalent to 6.35 mm
(1/4 inch), while a single side is 3.2 mm (1/8 inch) as
shown in Figure 57.
12. Adjust the height of the mower deck to the desired
height.
39
G015323
1
3
2
Figure 55
4. Side locking nut.
5. Side carriage bolt
1
2
G015324
Figure 56
3. Side locking nut, slotted
position.
4. Adjustment notches