Toro TimeCutter ZS 4200S Operator's Manual page 40

1
2
Figure 57
1. 6.35 mm (1/4 inch)
13. Stop the deck at the adjusted position, and tighten the
side locking nut on the hanger bracket to hold the new
position (Figure 56).
14. Tighten the rear locking nut on the hanger bracket.
15. Continue leveling the deck by checking the front-to-rear
blade slope; refer to Adjusting the Front-to-Rear Blade
Slope (page 40).
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install the
mower. If the front of the mower is more than 7.9 mm
(5/16 inch) lower than the rear of the mower, adjust the blade
level using the following instructions:
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Set the height-of-cut lever to middle position.
Note: Check and adjust the side-to-side blade level if
you have not checked the setting; refer to Side-to-Side
Leveling (page 38).
4. Carefully rotate the blades so they are facing front to
rear (Figure 58 and Figure 59).
G015325
2. 3.2 mm (1/8 inch)
2
Mower decks with 2 Blades
1. Blades front to rear
2. Measure from the tip of the blade to the flat surface here
3
G009659
Mower decks with 3 Blades
1. Blades front to rear
2. Outside cutting edges
5. Measure from the tip of the front blade to the flat
surface, and the tip of the rear blade to the flat surface
(Figure 58 and Figure 59).
Note: If the front blade tip is not 1.6 to 7.9 mm (1/16
to 5/16 inch) lower than the rear blade tip, adjust the
front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (Figure 60).
40
1
G009658
2
Figure 58
2
1
Figure 59
3. Measure from the tip of the
blade to the flat surface
here
2
3