Removing The Mower - Toro TimeCutter ZS 4200S Operator's Manual

1
1. Adjusting rod
2. Adjusting block
7. To raise the front of the mower, tighten the adjustment
nut.
8. To lower the front of the mower, loosen the adjustment
nut.
9. After adjustment, check the front-to-rear slope again,
continue adjusting the nut until the front blade tip is
1.6 to 7.9 mm (1/16 to 5/16 inch) lower than the rear
blade tip (Figure 58 and Figure 59).
10. When the front-to-rear blade slope is correct check
the side-to-side level of the mower again, refer to
Side-to-Side Leveling (page 38).

Removing the Mower

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Lower the height-of-cut lever to the lowest position.
4. Remove the hairpin-cotter pin from the front support
rod, and remove the rod from the deck bracket (Figure
61).
3
2
G014634
Figure 60
3. Lock nut
3
1. Front support rod
2. Locking nut
5. Carefully lower the front of the mower deck to the
ground.
6. Lift the mower deck and hanger brackets clear of
the rear lift rod and lower the mower carefully to the
ground (Figure 62).
2 2
1
1. Mower deck
2. Hanger bracket
7. Slide the mower deck rearward to remove the mower
belt from the engine pulley.
8. Slide the mower deck out from underneath the
machine.
41
2
1
G014635
Figure 61
3. Deck bracket
2 2
3 3
G005077
Figure 62
3. Rear lift rod