Toro TimeCutter ZS 4200S Operator's Manual page 23

G009660
Figure 25
1. Cap nut (1/4 inch)
2. Discharge cover
3. Bolt (1/4 x 2-1/2 inches)
4. Remove the discharge cover.
5. Lift up the grass deflector, and locate the lock nut on
the deflector pivot rod.
6. Remove the existing thin nut (3/8 inch).
7. Install the cutoff baffle to the exposed pivot rod
(Figure 26).
Note: Use the existing thin nut (3/8 inch) to secure
the baffle to the mower.
Note: The cutoff baffle was shipped with the machine
as a loose part.
G005667
Figure 26
1. Pivot rod
2. Cutoff baffle (originally
shipped with the machine)
8. Torque the fastener to 7 to 9 N-m (14 to 18 ft-lb).
1
2
3
4
5
4. Rotate the cover up
5. Remove the cover
1
2
3
3. Existing thin nut (3/8 inch)
9. Lower the grass deflector over the discharge opening
Important: Ensure that the mower has a hinged
grass deflector that disperses clippings to the side
and down toward the turf, while in side-discharge
mode.
Installing the Discharge Cover for
Mulching
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait
for all the moving parts to stop before leaving the
operating position.
3. Remove the cutoff baffle from the mower deck (Figure
26).
4. Lift the grass deflector and slide the tabs on top of the
discharge cover under the grass deflector retaining rod.
5. Rotate the discharge cover down over the opening, and
onto the lower lip of the mower (Figure 27).
1. Discharge cover
2. Cap nut (1/4 inch)
6. Secure the discharge cover to the lower lip of the
mower with 2 bolts (1/4 x 2-1/2 inches) and 2 cap nuts
(1/4 inch) as shown in Figure 27.
23
Figure 27
3. Bolt (1/4 x 2-1/2 inches)