Table of Contents
Advertisement
Right Joystick—Mode I
Note: The joystick controls vary depending on the control
mode you select when powering up the machine. There
are 2 control modes: Mode I and Mode II; refer to the
Control-Select Screen in the Software Guide for information
on setting the control mode.
1
5
6
7
Figure 15
1. Joystick—move left
2. Joystick—move forward
3. Joystick—move rearward
4. Joystick—move right
5. Toggle switch
Toggle Switch
Rock the switch forward to increase the rate of flow of the
drilling fluid; rock the switch rearward to decrease the rate
of flow of the drilling fluid.
Note: Before using this feature you must first turn on
the drilling-fluid pump using the lower button on the right
joystick.
Front Button
Press this button to apply tread-joint compound.
Rear Button
Press and hold this button for maximum drilling fluid
pressure; use this to quickly fill the pipe with drilling fluid
after adding or removing a pipe. Release the button to stop
the flow or return to the previously set flow rate.
2
4
3
8
9
g021833
6. Front button
7. Rear button
8. Lower button
9. Trigger
Lower Button
Press this button to turn the drilling-fluid pump on or off.
Trigger
Press and hold the trigger to move the drill carriage at high
speed up or down the drill frame.
Joystick—Forward
Push the joystick forward to thrust the drill carriage forward.
Joystick—Rearward
Pull the joystick rearward to pull the drill carriage rearward.
Joystick—Left
Push the joystick left to spin the drill spindle clockwise.
Joystick—Right
Push the joystick right to spin the drill spindle
counterclockwise.
25
Advertisement
Table of Contents
