Adjustment Via Ir Remote Control; Commands - B.E.G. LUXOMAT BL2 Operating Manual

6.3

Adjustment via IR remote control

The device can be adjusted by infrared remote control. No adjustments can be made to the device
itself.
The white LED of the detector flashes briefly fast to confirm the correct reception of an IR signal.
6.3.1

Commands

Button Command
Close detector (locked state)
When closed, only the switch illumination and RESET functions are available.
Open detector (unlocked state)
Press this key to open (unlock) the device for programming.
The settings for the day/night operation, the switch-on threshold, the follow-up time,
the detection sensitivity and the status LEDs can then be made. The procedure is ter-
minated automatically after 3 minutes of no further input or by pressing the 'Close
detector' button.
Reset to factory default settings
This command (long key press > 3 s) resets the device to its factory setting.
Factory default settings!
The individually made settings are lost.
Store brightness
This key is used to measure the ambient brightness and apply the value as the switch-
on threshold.
Switching the illumination
The illumination is switched on or off and the follow-up time is started.
Operating Manual
BL2
93055 – IR-BL
CAUTION
93317
15