Table of Contents
Advertisement
2.5 Trimmer Height Setup
With the trimmer positioned in its final location,
follow these steps to complete the trimmer
setup:
1. Remove the trimmer's lower front door and
raise the front end of the machine by adjust-
ing the front two leveling pads. The final ta-
ble height should be 36" (914mm) from the
floor. Use a level to make sure the table is
level from left to right.
2. Open the rear doors and raise the rear end
of the machine by adjusting the rear two lev-
eling pads until the trimmer table is level.
3. Check the front end of the machine with the
level to make sure the front is still level. Ad-
just as necessary.
4. Now lower the two pads at the center of the
machine such that the trimmer is firmly sup-
ported by all (6) leveling pads. Double-
check that the table is still level.
5. Lock all (6) leveling pads in place by tighten-
ing the jam nuts against the inside of the
machine's base as shown in Figure 2-30.
The nuts are accessed from below the ma-
chine.
Figure 2-30. Tighten Jam Nuts
CMT-330TC Three-Knife Trimmer
APR 2018
2-12
2. Installation Guide
Advertisement
Table of Contents
